Heng Long Smoke Unit

A Step By Step Visual Guide
Use this guide to replace faulty smoker units or to upgrade your non-smoke and sound tank.

1. Closeup of a smoke unit. Remove by unscrewing 3 screws from underneath the tank.	2. The smoke unit connects to a socket underneath the main receiver board. DP2 on RX13 or RX14 and CN10 on RX18 boards.	3. The switch for the smoke unit is located underneath the tank. Shown top left in photo.
4. Use only a few drops of smoke oil at a time. Too much oil will flood the chamber and render the smoke unit inoperable until it dries out.	5. Arrangement of pipes from smoke unit for a Tiger 1. Cut pipes to size as necessary.	6. Arangement of pipes from smoke unit for a M26 Pershing (Snow Leopard). Cut pipes to size as necessary.
7. Note position of smoke unit in a Tiger 1.

Categories